Tyre and service sites often combine short high-demand events with repeated inflation and workshop use. The compressor and receiver need to recover without excessive pressure drop during busy periods.
Common demand drivers
- tyre changers
- bead seating and inflation
- wheel service equipment
- impact tools
- multiple simultaneous operators
- required recovery time
Likely Pneumatix starting points
PM10 may suit smaller sites where measured simultaneous demand fits within 1,000 L/min at 8 bar. PM20 offers 2,100 L/min at 8 bar for busier or multi-user operations. Larger requirements may move toward PM30 after a proper demand assessment.
Total Air Station or Base Mount?
A Total Air Station provides a compact packaged arrangement. A Base Mount allows receiver capacity and air treatment to be selected around peak demand and the available plant layout.
Related products
Base Mount
PM10 Base Mount
PM10VSD
- 1,000 L/min at 8 bar
- 10 bar max pressure
- 7.5 kW / 10 HP
- Compressor only
Total Air Station
PM10 Total Air Station
PM10300VSD
- 1,000 L/min at 8 bar
- 10 bar max pressure
- 7.5 kW / 10 HP
- 300 L receiver
- 1.0 micron pre-filter
- 0.01 micron post-filter
Total Air Station
PM20 Total Air Station
PM20500VSD
- 2,100 L/min at 8 bar
- 10 bar max pressure
- 15 kW / 20 HP
- 500 L receiver
- 1.0 micron pre-filter
- 0.01 micron post-filter
Need help applying this to your site?
Provide the equipment list, operating pattern, required pressure and existing compressed-air infrastructure. Pneumatix can help identify the appropriate starting point or support the discussion with your existing dealer.
Frequently asked questions
Is a larger receiver a substitute for a larger compressor?
No. Storage can help with short peaks, but sustained demand still needs enough compressor output.
Which Pneumatix series suits a tyre shop?
The answer depends on the actual equipment and simultaneous use. PM10 and PM20 are the main starting points, but the final selection should be checked.
Can the compressor be installed away from the work area?
Yes, subject to ventilation, access, electrical supply and a correctly sized distribution system.
Do I need a dryer for tyre and workshop air?
Drying can help control downstream moisture. The required treatment depends on the equipment and site conditions.